Tools › Structures › Materials › Tensile Test Report › Example
Tension test with a yield point: upper and lower yield strength of a steel-like record
| Tool | Tensile Test Report |
| Source | original |
| Level | Undergraduate |
Problem
A 0.505 in round specimen with a 2 in gage length gives a record in which the force peaks, drops, runs along a plateau and then rises again. Find the upper and lower yield strength, the 0.2 % offset value for comparison, the ultimate strength and the elongation.
Inputs to Enter
- Data kind: force and extension, round specimen; force in lb, extension in in; 236 seeded illustrative rows (the second Try this case)
- Diameter 0.505 in, gage length 2 in, offset 0.2 %
Answers
- Elastic fit: rows 1 to 30, E = 29.49 Msi (generated with 29.5 Msi)
- Upper yield strength 44.01 ksi (row 30: the highest so far, followed by three rows more than 0.73 ksi lower); lower yield strength 40.35 ksi (generated with 44.0 and 40.38 ksi)
- The 0.2 % offset line meets the curve inside the drop, between rows 39 and 40: 40.69 ksi, between the two
- Ultimate strength 63.01 ksi at 19.7 % strain; fracture at 32.85 % strain, permanent elongation 32.68 %
- Toughness 18,330 psi (in-lb/in³); strain hardening from the end of the plateau to the maximum force: n = 0.304, K = 128.7 ksi
Notes
Open this case in the tool: /analysis-tools/structures/materials/tensile-test-report/?try=mild-steel-yield-point. Seeded synthetic data. The yield-point rule (a peak followed by three rows lower by more than 0.5 % of it and five times the scatter of the elastic fit) is the tool's own, stated on the page.
More Examples for This Tool
- Tension test of a 0.505 in round bar: modulus, 0.2 % offset yield, ultimate strength, elongation and toughness from 236 force-extension rows
- A brittle record that breaks before the 0.2 % offset line: no offset yield strength
- Toe compensation: a flat coupon whose record starts with 0.11 mm of slack
- MIL-HDBK-5J Table 9.8.4.1.1: the 0.2 % yield strength and the strain departures of a typical stress-strain curve