Tools › Structures › Materials › Tensile Test Report › Example
A brittle record that breaks before the 0.2 % offset line: no offset yield strength
| Tool | Tensile Test Report |
| Source | original |
| Level | Undergraduate |
Problem
A cast-iron-like specimen gives 62 rows of stress (MPa) and strain (%) that curve gently from the start and end in a sudden break at about 240 MPa and 0.30 % strain. Find the modulus and state whether the record has a 0.2 % offset yield strength.
Inputs to Enter
- Data kind: stress and strain; stress in MPa, strain in percent; 62 seeded illustrative rows with a header line (the third Try this case)
- Offset 0.2 %; unit system SI for the values below
Answers
- The header line names both columns; the record is cut at the break (2 later rows left out)
- Elastic fit over the first 15 rows: E = 108.5 GPa (15.73 Msi); the fit covers 32 % of the stress at the knee, so the modulus is a chord of a curve that bends from the start
- Largest stress 240.0 MPa (34.81 ksi) at 0.299 % strain, which is also the fracture point
- Plastic strain at fracture 0.299 − 100 × 240.0 / 108,450 = 0.077 %, less than the 0.2 % of the definition: the curve never meets the offset line and the page reports no offset yield strength, no modulus of resilience and no strain-hardening fit
- Toughness 0.407 MPa (MJ/m³), 58.97 psi
Notes
Open this case in the tool: /analysis-tools/structures/materials/tensile-test-report/?try=brittle-no-offset-yield (it opens in U.S. units; choose SI for megapascals). Seeded synthetic data generated with a plastic strain of 0.08 % at fracture.
More Examples for This Tool
- Tension test of a 0.505 in round bar: modulus, 0.2 % offset yield, ultimate strength, elongation and toughness from 236 force-extension rows
- Tension test with a yield point: upper and lower yield strength of a steel-like record
- Toe compensation: a flat coupon whose record starts with 0.11 mm of slack
- MIL-HDBK-5J Table 9.8.4.1.1: the 0.2 % yield strength and the strain departures of a typical stress-strain curve