Tools › Structures › Materials › Tensile Test Report › Example

Toe compensation: a flat coupon whose record starts with 0.11 mm of slack

ToolTensile Test Report
Sourceoriginal
LevelUndergraduate

Problem

A flat coupon 12.5 mm wide and 3 mm thick with a 50 mm gage length is recorded in kN and mm. Slack in the load train adds extension while the force is still small, so the curve starts with a toe. Find the strain zero, the modulus and the 0.2 % offset yield strength.

Inputs to Enter

  • Data kind: force and extension, flat specimen; force in kN, extension in mm; 255 seeded illustrative rows with a header line (the fourth Try this case)
  • Width 12.5 mm, thickness 3 mm, gage length 50 mm, offset 0.2 %; toe compensation applied (the default); unit system SI for the values below
Open the Tensile Test Report tool

Answers

  • Original area 12.5 × 3.0 = 37.5 mm²
  • Elastic fit: rows 6 to 24 of the box, above the toe and below the knee, E = 70.27 GPa (generated with 72.0 GPa: 2.4 % low)
  • The fitted line meets zero stress at 0.2165 % strain, and every strain is counted from there (the record was generated with 0.110 mm of slack, 0.22 % of 50 mm)
  • 0.2 % offset yield strength 293.0 MPa (model value 291.6 MPa); ultimate strength 442.5 MPa
  • Strain at the end of the record 16.50 %, permanent part 15.92 %; without toe compensation every strain would read 0.22 % higher, and the yield strength would be the same
  • Strain hardening n = 0.129, K = 658.7 MPa (generated with n = 0.130, K = 660 MPa)

Notes

Open this case in the tool: /analysis-tools/structures/materials/tensile-test-report/?try=toe-region-slack (it opens in U.S. units; choose SI for the values above). Seeded synthetic data. The record has no rows after the break, so its last row is taken as the fracture point.

More Examples for This Tool