Tools › Aerodynamics › Aircraft Certification

Aircraft Certification

2 tools in the Aerodynamics area.

Aircraft Electrical Load Analysis

A direct-current electric load and power source capacity analysis in the form and terms of MIL-E-7016F, for an equipment installation (supplemental type certificate, field approval, alteration): the connected load chart, the load analysis chart with the 5-second, 5-minute and continuous analyses of each operating condition, the power source utilization analysis (rating factors, source interval rating, adjusted source capacity, load requirements, growth capacity), the minimum growth capacity, and the battery analysis for the emergency condition and for loading and preparation. The continuous load is also checked against the 80 percent figure of FAA AC 43.13-1B paragraph 11-35, before and after the modification. Advanced mode adds one wire run by the AC's section 5: resistance from Table 11-9 or 11-10, the conductor temperature and resistance correction of paragraph 11-66d, the voltage drop against Table 11-6, the current rating and the circuit protector of Table 11-3. The default load list is an illustrative 14-volt single-engine airplane made for the page; the default wire run is the AC's Example No. 2. A drafting aid: the analysis of record, the essential-load list and the required battery duration are the applicant's and the approving authority's determination.

1 worked example reproduced, listed on the tool page.

Compliance Matrix Builder

Drafts the compliance checklist of a certification plan: choose 14 CFR Part 23, 25, 27, 29, 33 or 35, paste the rows section | means of compliance | document | remarks, add sections by subpart, by a list of numbers or by a keyword in the headings, and get a report-ready matrix with the current eCFR heading and subpart of every section, a status for every row, counts by means of compliance and by subpart, the pasted numbers that are not sections of the Part (with the nearest existing numbers) and the chosen sections not yet addressed. Section numbers and headings are those of the eCFR on 2026-11-13; the code table is editable and defaults to the ten codes 0 to 9 that EASA publishes for certification programs. A drafting aid: which sections apply, and at which amendment, is for the applicant and the authority to determine.

1 worked example reproduced, listed on the tool page.

Other Aerodynamics sections

Airfoils and Wings · Rotors and Ducted Fans · Aircraft Performance · Stability and Control · Atmosphere and Flight Conditions · Propulsion