Tools › Building Systems › Lighting and Electrical › Cable Pulling Tension › Example

An 80 ft riser: 773 lb pulling the cable up, 104 lb feeding it from the top

ToolCable Pulling Tension
Sourceoriginal
LevelProfessional

Problem

A single cable weighing 3.5 lb/ft runs 30 ft level, turns up through a 90 degree vertical bend of 3 ft radius, rises 80 ft vertically, turns back to level through a second 90 degree bend of 3 ft radius and runs 20 ft level. The coefficient of friction is 0.35 and the incoming tension 40 lb. Find the tension along the run when the cable is pulled up the riser (A to B) and when it is fed from the top and pulled out at the bottom (B to A).

Inputs to Enter

  • One cable, diameter 1.8 in, weight 3.5 lb/ft, conduit inside diameter 4.026 in, friction coefficient 0.35, incoming tension 40 lb
  • Rows: level 30 ft; vertical bend turning up 90°, R 3 ft; rising at 90°, 80 ft; vertical bend turning down 90°, R 3 ft; level 20 ft
Open the Cable Pulling Tension tool

Answers

  • A to B: 76.8 lb at the foot of the riser, 141 lb after the lower bend, 141 + 3.5 × 80 = 421 lb at the top of the riser, 749 lb after the upper bend, 773 lb at B
  • Upper bend, A to B: T_out = (420.7 + 6.548) × e^(0.35 × 1.571) + 8.208 = 749 lb; sidewall pressure 749 / 3 = 250 lb/ft
  • B to A: 64.5 lb entering the upper bend, 104 lb leaving it; the falling cable then outweighs the tension after 29.7 ft and the tension is held at zero (slack) down to the lower bend; 37.4 lb at A
  • Highest tension 773 lb pulled up against 104 lb fed from the top: 7.4 times

Notes

Open this case in the tool: /analysis-tools/buildings/electrical/cable-pulling-tension/?try=riser-fed-from-the-top. Where the page reports slack the cable is running ahead of the pull and has to be held back at the reel; the tension there depends on the brake, which is outside the calculation. The vertical bend equation is derived on the tool's method page and checked against a numerical integration. Illustrative numbers.

More Examples for This Tool