Tools › Structures › Statics › Truss by Joints and Sections › Example
Warren truss: three member forces from one section near midspan
| Tool | Truss by Joints and Sections |
| Source | Original example; hand statics with 6-8-10 triangles. |
| Level | Undergraduate |
Problem
A Warren truss without verticals spans 36 ft: bottom joints A, C, E, G at x = 0, 12, 24, 36 ft and top joints B, D, F at x = 6, 18, 30 ft, 8 ft above. A pin holds A and a roller G. Loads of 6,000 lb at C and 3,000 lb at E act downward. Find the forces in BD, CD and CE with one cut, and compare with the method of joints.
Inputs to Enter
- Joints in ft: A (0, 0), B (6, 8), C (12, 0), D (18, 8), E (24, 0), F (30, 8), G (36, 0)
- Members: AB, BC, CD, DE, EF, FG (diagonals), AC, CE, EG (bottom chord), BD, DF (top chord)
- Loads down: 6,000 lb at C, 3,000 lb at E; cut through BD, CD, CE
Answers
- Reactions: G_y = (6,000 × 12 + 3,000 × 24) / 36 = 4,000 lb, A_y = 5,000 lb
- Part A-B-C kept. ΣM_C = 0: −F_BD (8) − (5,000)(12) = 0 → F_BD = −7,500 lb (compression)
- ΣM_D = 0: F_CE (8) + (6,000)(6) − (5,000)(18) = 0 → F_CE = 6,750 lb (tension)
- ΣF_y = 0: F_CD (0.8) − 6,000 + 5,000 = 0 → F_CD = 1,250 lb (tension)
- By joints: AB 6,250 lb C, AC 3,750 lb T, BC 6,250 lb T, and the same three values for BD, CD and CE
Notes
Open this case in the tool: /analysis-tools/structures/statics/truss-joints-sections/?try=warren-midspan-cut. In SI the chip uses a 9 m span, 2 m depth, 30 kN and 15 kN: BD 37.5 kN C, CE 33.75 kN T, CD 6.25 kN T.
More Examples for This Tool
- Four-panel Pratt bridge truss: every member by the method of joints and three by one section
- Three-member triangular truss under a load with a sideways part
- Howe truss with an off-center load and a sideways force: unequal reactions and a section through parallel chords
- Cantilever truss on a wall: zero-force members at the free corner and a section that needs no reactions
- Fink roof truss with snow on one slope: a chain of zero-force members and a section with its moment point at the support