Tools › Structures › Statics › Truss by Joints and Sections › Example
Three-member triangular truss under a load with a sideways part
| Tool | Truss by Joints and Sections |
| Source | Original example; hand statics with a 3-4-5 triangle. |
| Level | Undergraduate |
Problem
A triangular truss has a pin at A (0, 0), a roller at B (8, 0) and its apex at C (4, 3), in feet. The apex carries 1,200 lb downward and 400 lb to the right. Find the reactions and the three member forces.
Inputs to Enter
- Joints in ft: A (0, 0), B (8, 0), C (4, 3); members AB, AC, BC
- Supports: pin at A, roller on a floor at B
- Loads at C: 1,200 lb down and 400 lb to the right (two rows)
Answers
- ΣM_A = 0: B_y (8) − (1,200)(4) − (400)(3) = 0 → B_y = 750 lb; A_y = 450 lb; A_x = −400 lb (to the left)
- Joint A: F_AC (0.6) + 450 = 0 → F_AC = −750 lb (compression); F_AB − 400 − (750)(0.8) = 0 → F_AB = 1,000 lb (tension)
- Joint B: F_BC (0.6) + 750 = 0 → F_BC = −1,250 lb (compression)
- Joint C is left as a check: both sums come to zero
Notes
Open this case in the tool: /analysis-tools/structures/statics/truss-joints-sections/?try=simple-triangle. The two sloping members are unequally loaded because of the sideways force; without it both would carry 1,000 lb in compression.
More Examples for This Tool
- Four-panel Pratt bridge truss: every member by the method of joints and three by one section
- Howe truss with an off-center load and a sideways force: unequal reactions and a section through parallel chords
- Warren truss: three member forces from one section near midspan
- Cantilever truss on a wall: zero-force members at the free corner and a section that needs no reactions
- Fink roof truss with snow on one slope: a chain of zero-force members and a section with its moment point at the support