Tools › Electrical and Controls › Circuits › Circuit Analysis (DC and AC) › Example
Series RLC circuit at resonance: 100 V across the capacitor from a 10 V source
| Tool | Circuit Analysis (DC and AC) |
| Source | original |
| Level | Undergraduate |
Problem
A 10 V rms source drives R = 10 Ω, L = 100 mH and C = 10 μF in series at ω = 1,000 rad/s, which is 1/√(LC). Find the current, the voltage across each element and the power.
Inputs to Enter
- AC steady state, 1,000 rad/s, rms values, ground node 0
- V1 10 V ∠ 0° from in (+) to 0; R1 10 Ω in–a; L1 100 mH a–b; C1 10 μF b–0
Answers
- Z_L = jωL = j100 Ω and Z_C = 1/(jωC) = −j100 Ω cancel, so the current is 10 / 10 = 1.000 A ∠ 0°
- Voltages: 10.00 V ∠ 0° across R1, 100.0 V ∠ 90° across L1, 100.0 V ∠ −90° across C1: ten times the source (Q = ω₀L/R = 10)
- P = 10.00 W, Q = 0, power factor 1.000
- The frequency sweep peaks at 100 V on node b exactly at 1,000 rad/s (159.15 Hz)
Notes
Open this case in the tool: /analysis-tools/electrical/circuits/circuit-analysis/?try=series-rlc-resonance. Illustrative values; a real coil's resistance would lower the peak.
More Examples for This Tool
- Unbalanced Wheatstone bridge: detector current by node equations and by the Thévenin equivalent
- Voltage divider: 24 V across 4, 8 and 12 Ω in series (DOE Fundamentals Handbook)
- Two batteries and three resistors: node-voltage analysis (DOE Fundamentals Handbook, Figure 45)
- Two loops with three voltage sources: the loop-equation example solved by node equations (DOE Fundamentals Handbook, Figure 37)
- Thévenin equivalent seen by a load, with a voltage source and a current source, and maximum power transfer
- RC low-pass filter at its corner frequency: output 0.707 of the input, 45° behind
- Series R-C circuit on 120 V, 60 Hz: impedance, power factor and the power triangle (DOE Fundamentals Handbook)