Tools › Units › Calculators › Calc Sheet › Example
A 180 kg machine on four 45 N/mm springs: static deflection, natural frequency and transmissibility
| Tool | Calc Sheet |
| Source | Original case; closed forms of the undamped single-degree-of-freedom oscillator. |
| Level | Undergraduate |
Problem
A 180 kg machine running at 24.2 Hz (1,450 revolutions per minute) stands on four springs of 45 N/mm each. Treating it as one mass on one spring without damping, find the static deflection, the natural frequency, the frequency ratio and the share of the force that reaches the floor.
Inputs to Enter
- m_1 = 180 kg, k_1 = 45 N/mm, n = 4, f_run = 24.2 Hz
- k = n * k_1 in kN/m; delta_st = m_1 * g_0 / k in mm
- omega_n = sqrt(k / m_1); f_n = omega_n / (2 * pi) in Hz; T_n = 1 / f_n in s
- r = f_run / f_n; TR = 1 / (r^2 - 1); check r > sqrt(2); check TR < 0.1
Answers
- k = 4 · 45.00 N/mm = 180.0 kN/m; δ_st = 180.0 kg · 9.807 m/s² / 180.0 kN/m = 9.807 mm
- ω_n = √(180,000 / 180) = 31.62 1/s; f_n = 31.62 / (2π) = 5.033 Hz; T_n = 0.1987 s
- r = 24.20 / 5.033 = 4.808, above √2 = 1.414: isolation, OK
- TR = 1 / (4.808² − 1) = 0.04521: about 4.5 % of the force is transmitted, OK
Notes
Open this case in the tool: /analysis-tools/units/calculators/calc-sheet/?try=spring-mass-frequency. The mass is named m_1 because a variable called m would take the place of the meter on the lines below it. The circular frequency prints in 1/s; the sheet gives Hz only where a line asks for it.
More Examples for This Tool
- A tie rod in mixed units: 12 kN on a 0.5 in rod, stress in MPa and ksi, stretch in mm
- Bolted lap joint: bolt shear, plate bearing and the governing capacity with entered allowables
- Darcy-Weisbach pressure drop of 12 L/s in a 100 mm pipe with an entered friction factor
- Heat loss through a three-layer wall: resistances in series, overall coefficient, watts and kWh per day