Tools › Structures › Beams › Torsion of Bars and Shafts › Example
Stepped shaft fixed at both ends with a torque at the step: reactions by compatibility
| Tool | Torsion of Bars and Shafts |
| Source | Original case (illustrative numbers); checked against an independent stiffness-matrix solution (References/Torsion-of-Bars/checks/torsion_check.py). |
| Level | Undergraduate |
Problem
A solid steel shaft (G = 11.5 Msi) is held at both ends. The left 20 in is 2 in in diameter and the right 30 in is 1.5 in in diameter; a torque of 10,000 lb-in is applied where they meet. Find the torque each wall takes, the largest shear stress and the rotation of the step.
Inputs to Enter
- Analyze: stepped round shaft; right end fixed
- Segment 1: length 20 in, diameter 2 in, torque at its right end 10,000 lb-in
- Segment 2: length 30 in, diameter 1.5 in, torque 0 (the right wall)
Answers
- Flexibilities f = L / (G J): 1.107 × 10⁻⁶ and 5.249 × 10⁻⁶ rad per lb-in
- Compatibility: (10,000 + T_B) f₁ + T_B f₂ = 0, so T_B = −10,000 × f₁ / (f₁ + f₂) = −1,742 lb-in and T_A = −8,258 lb-in
- Largest shear stress 16 × 8,258 / (π × 2³) = 5.257 ksi in the thicker segment; the thinner one carries 2.629 ksi
- The step turns 0.524°; both ends stay put
Notes
Open this case in the tool: /analysis-tools/structures/beams/torsion-of-bars/?try=fixed-fixed. The stiffer segment (short and thick) takes most of the torque. The stress at the shoulder fillet is higher than these values; the tool does not treat stress concentration.
More Examples for This Tool
- Thin-walled rectangular tube in torsion, closed and slit (NASA Astronautic Structures Manual example)
- Solid shaft sized from power and speed: torque, shear stress, twist and required diameter
- Hollow shaft against the solid shaft of the same weight: stress and stiffness
- Rectangular bar in torsion: Saint-Venant coefficients, largest stress at the middle of the long side