Tools › Structures › Beams › Torsion of Bars and Shafts › Example
Rectangular bar in torsion: Saint-Venant coefficients, largest stress at the middle of the long side
| Tool | Torsion of Bars and Shafts |
| Source | National Aeronautics and Space Administration (1975). Astronautic Structures Manual, Volume II. NASA Technical Memorandum X-73306, George C. Marshall Space Flight Center, Marshall Space Flight Center, AL. Section B8.2.3, Example Problem 1, p. 18 of Section B8.2 (the bar and its loading); Table B8.2.2-1, p. 11. The coefficients are computed from the exact series and checked against an independent finite-difference solution. |
| Level | Undergraduate |
Problem
A solid rectangular bar 5 in by 2.5 in, 32 in long, G = 4,000,000 psi, carries a torque of 100,000 in-lb. Find the largest shear stress and where it acts, the stress at the middle of the short sides, and the angle of twist.
Inputs to Enter
- Analyze: rectangular bar; torque 100,000 lb-in
- Long side 5 in, short side 2.5 in, length 32 in, shear modulus 4 Msi
Answers
- a / b = 2: β = 0.2287, α = 0.2459 from the series (table β 0.229)
- J = β a b³ = 0.2287 × 5 × 2.5³ = 17.87 in⁴; twist T L / (G J) = 0.04478 rad = 2.566°
- Largest shear stress T / (α a b²) = 13.01 ksi at the middle of each long side; 10.35 ksi at the middle of each short side; zero at the corners
- The polar moment of area, a b (a² + b²) / 12 = 32.55 in⁴, is 1.8 times J: using it would understate the twist by that factor
Notes
Open this case in the tool: /analysis-tools/structures/beams/torsion-of-bars/?try=rect-bar. The manual's printed answers for this bar differ: it uses α = 0.256 from its table (12,500 psi), a value 4.1 % above the exact series coefficient, and it evaluates K as β b d² (7.156) instead of β b d³, which gives 0.1118 rad. The β row of the table agrees with the series.
More Examples for This Tool
- Thin-walled rectangular tube in torsion, closed and slit (NASA Astronautic Structures Manual example)
- Solid shaft sized from power and speed: torque, shear stress, twist and required diameter
- Hollow shaft against the solid shaft of the same weight: stress and stiffness
- Stepped shaft fixed at both ends with a torque at the step: reactions by compatibility