Tools › Structures › Beams › Torsion of Bars and Shafts › Example

Thin-walled rectangular tube in torsion, closed and slit (NASA Astronautic Structures Manual example)

ToolTorsion of Bars and Shafts
SourceNational Aeronautics and Space Administration (1975). Astronautic Structures Manual, Volume II. NASA Technical Memorandum X-73306, George C. Marshall Space Flight Center, Marshall Space Flight Center, AL. Section B8.3.4, Example Problem 1, pp. 20–21 of Section B8.3. The slit-tube comparison is original.
LevelUndergraduate

Problem

A rectangular tube 6 in by 3 in outside with a 0.2 in wall, 60 in long, G = 4,000,000 psi, carries a torque of 100,000 in-lb. Find the shear stress in the wall away from the corners, the torsion constant and the angle of twist. Then slit the tube along its length and compare.

Inputs to Enter

  • Analyze: rectangular tube, thin wall; torque 100,000 lb-in
  • Outside width 6 in, outside height 3 in, wall thickness 0.2 in
  • Length 60 in, shear modulus 4 Msi
Open the Torsion of Bars and Shafts tool (loaded with this example)

Answers

  • Area enclosed by the wall mid-line A = 5.8 × 2.8 = 16.24 in² (book 16.24); mid-line length 17.2 in (book 17.2)
  • Shear stress τ = T / (2 A t) = 100,000 / (2 × 16.24 × 0.2) = 15.39 ksi (book 15,394 psi); shear flow 3,079 lb/in
  • Torsion constant J = 4 A² t / p = 12.27 in⁴ (book 12.27); twist 0.1223 rad = 7.01° (book 0.122 rad)
  • Slit along its length: J = p t³ / 3 = 0.04587 in⁴, 267 times less; stress 436 ksi, 28 times more (a ratio, not a working state)

Notes

The tool opens on this case; press Submit, or open it in the tool: /analysis-tools/structures/beams/torsion-of-bars/?try=nasa-tube. The manual goes on to raise the stress at the inside corners by a factor of 1.7 for the 0.1 in corner radius; the tool does not treat corners and says so.

More Examples for This Tool