Tools › Mechanical Design › Vehicle Dynamics › Pinewood Derby Car › Example
Gravity derby car: a body 0.6 in high against one 1.75 in high
| Tool | Pinewood Derby Car |
| Source | Original case. The drag coefficient 0.8 on the frontal area body width × body height and the air density 1.2 kg/m³ are illustrative values typed from memory. |
| Level | Undergraduate |
Problem
Two 5 oz derby cars 1.75 in wide differ in profile: a wedge 0.6 in high with its center of mass 0.35 in above the track, and a block 1.75 in high with its center of mass at 0.7 in. Both use the drag coefficient 0.8. How much of the difference at the finish is air drag, and how much the lower center of mass?
Inputs to Enter
- Advanced mode. Your car: 5 oz, balance point 1.0 in, center of mass 0.35 in high, body height 0.6 in, body width 1.75 in, drag coefficient 0.8
- Rival: another car, balance point 1.0 in, center of mass 0.7 in high, body height 1.75 in
- Track: start height 4 ft, length 35 ft, ramp 25°, curve radius 4 ft
Answers
- Drop of the center of mass 50.08 in against 50.05 in: the height of the center of mass changes the drop by 0.03 in
- Air drag takes 3.72 % of the energy against 10.43 %
- Finish 2.8864 s at 14.95 ft/s against 2.9271 s at 14.36 ft/s: 0.041 s, 7.03 in at the line, 1.0 car length
Notes
Open this case in the tool: /analysis-tools/mechanical/vehicle-dynamics/pinewood-derby/?try=low-wedge. Nearly all of the gain is air drag. A low center of mass gains a little height on the tilted ramp and loses about as much in the curve, where a high center of mass runs on a slightly shorter path.
More Examples for This Tool
- Gravity derby car: balance point 1 in ahead of the rear axle against the middle
- Gravity derby car: 1.0 g wheels against 2.6 g wheels at the same total weight
- Gravity derby car: axle friction coefficient 0.12 against 0.25
- Gravity derby car: 5.0 oz against 4.0 oz, and why the heavier car wins
- Gravity derby car: every change at once against a plain kit build