Tools › Structures › Stress and Strain › Failure Theories › Example
Thin pressure vessel wall: the zero principal stress that decides the maximum shear stress
| Tool | Failure Theories |
| Source | Original case. Theories as stated in National Aeronautics and Space Administration (1975). Astronautic Structures Manual, Volume I. NASA Technical Memorandum X-73305, George C. Marshall Space Flight Center, Huntsville, AL. Section A1.4, pp. 34–35. |
| Level | Undergraduate |
Problem
The wall of a thin cylindrical pressure vessel carries a hoop stress of 120 MPa and an axial stress of 60 MPa (the 2 : 1 ratio of a closed cylinder); the stress through the wall is neglected. The yield strength is 250 MPa (illustrative). Find the factor of safety against yielding by both ductile theories.
Inputs to Enter
- Plane stress: σ_x = 120 MPa (hoop), σ_y = 60 MPa (axial), τ_xy = 0
- Ductile material, yield strength S_y = 250 MPa (illustrative)
Answers
- Principal stresses σ_1 = 120 MPa, σ_2 = 60 MPa, σ_3 = 0: the free-surface zero is the smallest
- Maximum shear stress (Tresca): σ_1 − σ_3 = 120 MPa, n = 250 / 120 = 2.08 (using the in-plane difference of 60 MPa would give a wrong 4.17)
- Distortion energy (von Mises): σ′ = 120 · √3 / 2 = 103.9 MPa, n = 250 / 103.9 = 2.41
Notes
Open this case in the tool: /analysis-tools/structures/stress-strain/failure-theories/?try=pressure-vessel. Numbers checked in test_failure_theories.php against closed forms and an independent numpy calculation.
More Examples for This Tool
- Shaft in pure torsion: yield at 0.5 or 0.577 of the yield strength (Tresca against von Mises)
- Brittle material in tension and compression: maximum normal stress, Coulomb-Mohr and modified Mohr compared
- Six stress components: principal stresses from the characteristic cubic and the yield factors of safety