Tools › Fluids and Heat Transfer › Fluid Statics › Hydrostatic Force and Buoyancy › Example

Hoover Dam: water force on each foot of width of a wall as high as the dam, and the pressure at its base

ToolHydrostatic Force and Buoyancy
SourceU.S. Department of the Interior, Bureau of Reclamation (2015). Hoover Dam: Frequently Asked Questions and Answers, the Dam. Lower Colorado Region, Boulder City, NV (height 726.4 ft from foundation rock to the roadway on the crest; maximum water pressure at the base 45,000 pounds per square foot).
LevelUndergraduate

Problem

Hoover Dam is 726.4 ft high. Treat its upstream face as a plain vertical wall with fresh water (62.4 lb/ft³) standing as deep as the dam is high. Find the force of the water on each foot of width, where it acts, and the pressure at the base, and compare the pressure with the figure the Bureau of Reclamation publishes.

Inputs to Enter

  • Calculation: force on a flat surface; liquid: fresh water, 62.4 lb/ft³
  • Rectangle 1 ft wide, 726.4 ft high, vertical (90°), top edge at the surface (depth 0), no hinge
Open the Hydrostatic Force and Buoyancy tool (loaded with this example)

Answers

  • Depth of the centroid h_c = 726.4 / 2 = 363.2 ft
  • Force F = γ h_c A = 62.4 · 363.2 · 1 · 726.4 = 16,460,000 lb on each foot of width (about 8,230 tons)
  • Center of pressure e = h² / (12 h_c) = 121.1 ft below the centroid: 484.3 ft deep, two-thirds of the way down
  • Pressure at the base = 62.4 · 726.4 = 45,330 lb/ft² (Bureau of Reclamation: 45,000 lb/ft²)

Notes

The tool opens on this case; press Submit, or open it in the tool: /analysis-tools/thermal-fluids/fluid-statics/hydrostatic-force-buoyancy/?try=hoover-dam. Only the height and the base pressure are published figures; the water is taken as deep as the dam is high (the lake stands a little lower), and the real dam is a curved arch-gravity structure that also carries uplift, silt and earthquake loads, so the force is an illustration of the formula, not a load on the real dam.

More Examples for This Tool